I haven't programmed one of these in a while so as usual I am not doing well. I updated the firmware. It's a PDM 25 and for starters I can't get the keypad to work. It has power and ground but when I set it up it doesn't show as connected in the monitor and it doesn't light up except when it is first turned on.
Any thoughts?
If I ever can’t get a keypad to work, I start at 125kb and ID decimal 21 hex 15. If it works, you know the speed needs to be changed.
The new can analyzer is also really helpful.
Lastly the keypad could still be in J1939. If so you will set speed to 250kb and send commands with can analyzer.