Hi, I am doing my due diligence and planning the wiring layout before purchasing a PDM 25 for my rally car. When looking at the pinout table I can see a couple of Outputs are assigned to more than one pin :
Output 25 B10 & B3
Output 24 D10 & D3
Is this by design or an error in the documentation? I am unable to see any reference in the web install manual.
Thanks
Brilliant and perfect for my needs. Thanks
this was by design to fill all the pins. it is still limited to 20A. So it could be used for headlights, or tails, or anything that may need 2 wires and is under 20A