Canbus keypad configure
Hi I'm totally new with canbus and pdm so it would be great if i could get some advice All is connected and works as it should but there are som minor things that i cannot figure out On the Blink marine keypad i wan't to control low beam/high beam on one button So state 1 low beam
state 2 high beam I just cannot figure out how to control each one of them... As it is now i trigger both outputs on both states. Wipers as for the same State 1 intermitent
State 2 slow speed
State 3 high speed
For headlight flash The turn signal/highbeam switch is oem and High beam goes to ground and cannot go to Highside wich would be the best and easiest.
When i activate Low side it triggers the output and flickers on and off and if i adjust the voltage it goes to stable ON
Should i just connect a Resistor to get a better situation for this or what should i do??
please add screenshots of your logic. you can set a single button to multistate. but it will scroll thru Off, Low beam, high beam, off etc. you may be better having button to turn lights on. and then use stalk for high beams and use logic to turn off low beams. Wipers will be the same thing, its going to cycle thru off, int, speed 1, speed 2, off You may be able to use some generic functions, math channels,counters to cycle what you want. i generally use the stock stalk, and then a button for the int speed.