Holley Dominator CAN Setup on PDM25+ V1. v1.15
Trying to get Holley Dominator CAN data working on an older Hardwire PDM25+ V1. Firmware 1.15
The newer PDM28 imports the Holley DBC fine, but the older PDM25 software doesn’t have a Float data option.
I know this has been done before. Does anyone have the correct setup or an old Holley/PDM25 configuration they can share?
Mainly trying to get RPM, MAP, TPS, coolant temp, etc. working over CAN.
129 Views
Well I noticed v 1.16 has the data format: float available but I've been unsuccessful using that version, whenever I send a simple output command it hangs the PDM. Maybe I'll try again. Not ready to give up yet. Especially since the whole car is wired up