Tech Forum

Hi all I have a 10 key pad and I am unable to get a little test function to work. I have all of my devices on the CAN bus and the PDM reads the ECU data but is unable to see the key pad signal.

I am sure of the following:

-Baud rate is correct and I changed it to 1000kbps, I know this because I can see the button presses with a CAN sniffer along with the ECU data.

I have tried all the different CAN IDs that I have seen on the BUS from the pad, but still no luck. I can also see some data from the PDM that it is continually sending.

I guess my questions are is the 10 key pad supported and or am I doing something wrong?

Here is some sample data from the pad when pressing button 1. For some reason the forum is telling check my internet connection or I would upload a copy of the current config. I can email if requested.