top of page

Tech Forum

Public·24 members

software update

First, I dont know if this is the right spot, but these new forums are impossible to browse.


I just updated my PDM15 to 1.1.6 and man what a disaster that was. It deleted all my configurations, which whatever ill resend it.


Well resending it, while works, causing the connection to freeze (the send button keeps "loading" and the tx/rx bits freeze in connection info). So after fighting that for 15 min come to find out it actually is sending the config still.


Then come to find out it deletes all the CAN configs from the PDM, so even though the saved config had all my outputs setup based on CAN inputs, all those were now undefined. So had to reload can config files, and then go into all my outputs and reconfigure the function to repoint to the correct CAN input.


Maybe i missed a note somewhere saying the firmware update would cause all these issues, because i would have never done it had I known it would cause so much chaos

212 Views
George
George
May 25

When the firmware is updated it clears the config yes

About

Technical advice and information for the Hardwire Electronic...

bottom of page