Start / Stop and indicators
After some research I have not manged to get any answers or at least recent answers as things change.
Using a PDM25+and Canbus Keypad - I have two buttons left and right for indicators. Can you make the keypad button flash on / off like on a oem vehicle?
I have the Start/Stop button set as momentary to start the car. All works fine. Are you able to set "something up" so when you press it again it stops, again like an oem vehicle.
Many thanks for your time.
225 Views
for 2 - you need to check if the engine is running to determine what to do, you could have 3 states, press for ignition on, again to start and then again to switch off. When starting you need to ensure the starter is switched off when engine rpm reached a threshold or timer expires. It gets complicated very quickly. Not done this on Hardwire PDM though. Good luck!