30 amp required output on pdm15/25
I have an onboard compressor that I am trying to install that will require 30 amps but only have a run time of 15 seconds and will not run often. I have seen some say to split the load between two outputs. What is the best way to go about splitting the wire to the outputs to achieve the 30a requirement? Solder?
81 Views
It as easy as just taking both output wires to the compressor. It will draw on both output equally. Just set the fuse points where you want them. On a side note I’m running on board air for my boost controller. I had to end up increasing the Peak fuse to above 40 to get the compressor started. Inrush on a compressor is hi. Just make sure the two output are identical. I’m running a pdm28 so I used one of the 30a outputs for it but I have two of the 20a outputs running to my fuel pump.