Tech Forum

Hi team, I am just getting set to upload my config file to my PDM25 and have attempted to update the firmware on the bench powered by USB. Once completed the update to 1.1.6 the PDM connects to PC again but stays in Firmware update mode according to the data in LH bar. The last step in update was to upload a blank config file but I left it for 20 mins or so and nothing was happening, just the circle of death. Where am I going wrong?

Is it possible to change the state of a buttons on the keypad? I want to set buttons for cool-down mode that will turn on water pump and fans until it has cooled down enough, then I would like this buttons to return to the off states.

We have installed 5 cars with PDM25 running the entire car. All of them runs ok, no issues at all

We install a new car, and in this case the PDM restarts at cranking, and it is related to the pdm because we move the pdm to another cars and the fault follows the PDM (wirings are exactly the same, so we just swaps the pdms between them). If i crank the car with the PDM connectet to the laptop, the car runs perfectly

Without the laptop connected, if i keep pushing the cranking button for 5-6 seconds, the pdm restarts and then, the car runs. I wanna know if the unit is defective, or maybe there is a firmware issue or similar.

Picture of the car just for attention

Regards

Hello. I have a weird issue. My car will only start when I connect my laptop to the PDM15. When the laptop is not connected I can hear the start seloniod click but it doesn’t crank. Is there a configuration update I can make to correct this?

First, I dont know if this is the right spot, but these new forums are impossible to browse.

I just updated my PDM15 to 1.1.6 and man what a disaster that was. It deleted all my configurations, which whatever ill resend it.

Well resending it, while works, causing the connection to freeze (the send button keeps "loading" and the tx/rx bits freeze in connection info). So after fighting that for 15 min come to find out it actually is sending the config still.

Then come to find out it deletes all the CAN configs from the PDM, so even though the saved config had all my outputs setup based on CAN inputs, all those were now undefined. So had to reload can config files, and then go into all my outputs and reconfigure the function to repoint to the correct CAN input.

Maybe i missed a note somewhere saying the…

Hi,

I am documenting my wiring and after reading and taking some notes I found that some outputs (24 and 25) are duplicated.

What is the correct pinout?

Thanks,

Lucas

Hi,

I have one of the Blink Marine keypads and the PDM28. I am looking for a way to use a single button to turn on ACC, IGN, start the engine and turn everything off. I'm trying to mimic a normal car's push button start.

I've thought about using the different states of the keypad button-state 1 is ACC and state 2 is IGN. The problem will come with state 3 which would be to engage the starter. There is no logic I can see where I can put conditions in for the different states. I would only want the button to go to state 3 if the brake was pressed, no RPM and the gear is park or neutral.

Is there a way to accomplish this?

Thanks

Technical advice and information for the Hardwire Electronics Products

Afternoon, I currently have a output not working on my pdm 28 when it should. i have confirmed the output is active in the program and checked the voltage at the pin with no voltage.

send me a email address and I'll send my file to you

Thanks for you time

Andrew Curtis